Flip Key - Ford

How to use the Ford Flip Key meant for the Mk4 Mondeo on your Late Mk2/Mk3 Mondeo.

Items Needed

1 Ford Flip Key

1 Blank cut to your current key

1 Replacement pats chip

Method

Separate remote part from folding part of key.

Split the plastic part of the key to pieces but you can drift out the pin without doing so. (If you half unfold the key you will see the blade retaining pin. This can be knocked out using a small drift.) That is how Ford fit the blade to the key in the first place.

Take your new blank key and remove all of the plastic, we are only after the blade shank.

Re-profile the end of the new key shank so it's the same as the shank that you have removed. You may need to slim down the sides of the shank so it will fit. One in place refit the pin that you took out earlier, if you are having problems you can use super glue to hold the blade in as well.

Now we need to remove the "old" pats chip as this is no longer required. Once this is out, we need to make space for the "new" pats chip. If you look on the other half of the plastic part you see where you can put the chip, you will need to cut/remove the webs to make space for the chip.

Once you have made space for the chip you can reassemble the key.

On the remote you will need to remove part of the plastic to make the remote fit with the "new" pats chip. You may find that the key slot is narrow for the "new" key shank, so you may have to widened this slot. Once the key fit's the slot you can reprogram the key to car is the normal way.

Programming Instructions

Programming of Remote

you will need all your remote's for this

Insert a programmed key into the ignition.

Turn key to position 2 & back four times within 6 second.

Hhen you turn the ignition off after the fourth turn you should hear a beep to tell you your in programming mode for the next 10 seconds.

Press any button on your new remote ( a tone will be heard when the car accepts the button press ) now do the same with your old remote's too.

Either switch the ignition back on or wait until the timer runs out on the programming mode & your done

Coding key to start the car

Complete each of the following steps within 5 seconds.

Insert first programmed key in the ignition & turn to position 2

Turn the key back to position 0 & remove from the ignition

Insert second programmed key in the ignition & turn to position 2

Turn back to position 0 & remove the second key, the system is now in programming mode.

Now insert you new key & turn to position 2 ( within 10 seconds )

Turn the ignition back to 0 & remove the key & then wait for five seconds.

Now try to start the car with your new key, if done ok the car will start, if its failed then the red LED in the clock will flashes after the ignition is switched on.