Registrations
We now manually approve all new user accounts due to a large influx of spam bots. Accounts are normally approved within 48 hours.
If you need any help with using this Wiki, please ask here: TalkFord.com Wiki Submission Forum
Difference between revisions of "Steering Wheel & Airbag Removal - Mk3"
Compuwiz uk (Talk | contribs) m (moved MK3 Airbag to Steering Wheel & Airbag Removal - Mk3) |
Compuwiz uk (Talk | contribs) |
||
Line 39: | Line 39: | ||
− | If the ignition has recently been switched on then you will have to wait 15 minutes minimum | + | If the ignition has recently been switched on then you will have to wait 15 minutes minimum for the airbag system to fully discharge or disconnect the battery & wait again just to be 100% safe. |
− | + | ||
− | for the airbag system to fully discharge or disconnect the battery & wait again just to be | + | |
− | + | ||
− | 100% safe. | + | |
== Parts Required == | == Parts Required == | ||
Line 58: | Line 54: | ||
− | Optional - Power Bar incase the t-bar aint shifting the bolt ( it can be tight if never undone | + | Optional - Power Bar incase the t-bar aint shifting the bolt ( it can be tight if never undone since the car was made ) |
− | + | ||
− | since | + | |
Line 75: | Line 69: | ||
− | Turn the ignition key just enough to unlock the steering lock ( but dont engage the ACC / I | + | Turn the ignition key just enough to unlock the steering lock ( but dont engage the ACC / I Position ( if you do engage said position then switch off the ignition & make sure to wait 15 mins before you progress further to allow the airbag system to drain - unless you have disconnected the battery of coarse ) |
− | + | ||
− | Position ( if you do engage | + | |
− | + | ||
− | further to allow the airbag system to drain - unless you have disconnected the battery of | + | |
− | + | ||
− | coarse ) | + | |
[[Image:MK3_Steering_Wheel_Change_-_ignition.jpg]] | [[Image:MK3_Steering_Wheel_Change_-_ignition.jpg]] | ||
Line 89: | Line 77: | ||
[[Image:MK3_Steering_Wheel_Change_1.jpg]] | [[Image:MK3_Steering_Wheel_Change_1.jpg]] | ||
− | Locate the screw hole that is now at the top of the steering wheel back & insert the torx | + | Locate the screw hole that is now at the top of the steering wheel back & insert the torx screwdriver & undo the screw |
− | + | ||
− | screwdriver & undo the screw | + | |
[[Image:MK3_Steering_Wheel_Change_2.jpg]] | [[Image:MK3_Steering_Wheel_Change_2.jpg]] | ||
− | Turn the steering wheel 1800 degree's in the opposite direction & undo the screw found at that | + | Turn the steering wheel 1800 degree's in the opposite direction & undo the screw found at that side. |
− | + | ||
− | side. | + | |
[[Image:MK3_Steering_Wheel_Change_3.jpg]] | [[Image:MK3_Steering_Wheel_Change_3.jpg]] | ||
− | While making sure to support the airbag for falling, turn the steering wheel to the straight | + | While making sure to support the airbag for falling, turn the steering wheel to the straight ahead position & remove the ignition key & enable the steering lock. |
− | + | ||
− | ahead position & remove the ignition key & enable the steering lock. | + | |
[[Image:MK3_Steering_Wheel_Change_4.jpg]] | [[Image:MK3_Steering_Wheel_Change_4.jpg]] | ||
− | carefully pull the airbag forwards & suitably support it to allow you to work behind the | + | carefully pull the airbag forwards & suitably support it to allow you to work behind the airbag. |
− | + | ||
− | airbag. | + | |
[[Image:MK3_Steering_Wheel_Change_5.jpg]] | [[Image:MK3_Steering_Wheel_Change_5.jpg]] | ||
− | Now undo the 2 clips on the rear of the airbag itself ( just squeeze the little tabs at the | + | Now undo the 2 clips on the rear of the airbag itself ( just squeeze the little tabs at the side & pull normally, occasionally though your airbag may have actually been fitted correctly & the locking tabs applied so if the side tabs do not press, slide the yellow locking tab towards the rear of the plug ( where the cables are ) & then try the tabs again. |
− | + | ||
− | side & pull normally, occasionally though your airbag may have actually been fitted correctly | + | |
− | + | ||
− | & the locking tabs applied so if the side tabs do not press, slide the yellow locking tab | + | |
− | + | ||
− | towards the rear of the plug ( where the cables are ) & then try the tabs again. | + | |
[[Image:MK3_Steering_Wheel_Change_6.jpg]] | [[Image:MK3_Steering_Wheel_Change_6.jpg]] | ||
Line 128: | Line 102: | ||
Now for the final connection holding the airbag inpace, the horn/cruise buttons connector. | Now for the final connection holding the airbag inpace, the horn/cruise buttons connector. | ||
− | Using a small flat screwdriver/bit push the locking tab down on the connector plug & pull the | + | Using a small flat screwdriver/bit push the locking tab down on the connector plug & pull the plug from the clockspring. |
− | + | ||
− | plug from the clockspring. | + | |
[[Image:MK3_Steering_Wheel_Change_10.jpg]] | [[Image:MK3_Steering_Wheel_Change_10.jpg]] | ||
Line 137: | Line 109: | ||
[[Image:MK3_Steering_Wheel_Change_13.jpg]] | [[Image:MK3_Steering_Wheel_Change_13.jpg]] | ||
− | Now you can remove the airbag & store it safely ( badge side facing upwards just incase it | + | Now you can remove the airbag & store it safely ( badge side facing upwards just incase it goes off ( then you dont have to remember to watch for it coming down again when it scares the life out of you :} - never had this happen after many airbags have been removed but best to advise about it being possible. |
− | + | ||
− | goes off ( then you dont have to remember to watch for it coming down again when it scares | + | |
− | + | ||
− | the life out of you :} - never had this happen after many airbags have been removed but best | + | |
− | + | ||
− | to advise about it being possible. | + | |
=== Steering Wheel Removal === | === Steering Wheel Removal === | ||
− | Undo the bolt in the middle of the steering wheel a few turns - & only a few turns mind, you | + | Undo the bolt in the middle of the steering wheel a few turns - & only a few turns mind, you dont want that bolt out fully just yet. |
− | + | ||
− | dont want that bolt out fully just yet. | + | |
[[Image:MK3_Steering_Wheel_Change_14.jpg]] | [[Image:MK3_Steering_Wheel_Change_14.jpg]] | ||
− | Now give the steering wheel a good tug & it should pop loose & stop when it hits the bolt once | + | Now give the steering wheel a good tug & it should pop loose & stop when it hits the bolt once again ( best done this way than getting a face full of steering wheel if the bolt is fully removed with the wheel still stuck inplace - the wheel may not always be stuck but when it is its on well lol ) |
− | + | ||
− | again ( best done this way than getting a face full of steering wheel if the bolt is fully | + | |
− | + | ||
− | removed with the wheel still stuck inplace - the wheel may not always be stuck but when it is | + | |
− | + | ||
− | its on well lol ) | + | |
[[Image:MK3_Steering_Wheel_Change_15.jpg]] | [[Image:MK3_Steering_Wheel_Change_15.jpg]] | ||
− | This piccy shows the spring mounted behind the wheel that helps you get a face full of wheel | + | This piccy shows the spring mounted behind the wheel that helps you get a face full of wheel if you fully remove the bolt when the wheel is stuck inplace. |
− | + | ||
− | if you fully remove the bolt when the wheel is stuck inplace. | + | |
[[Image:MK3_Steering_Wheel_Change_16.jpg]] | [[Image:MK3_Steering_Wheel_Change_16.jpg]] | ||
− | Make sure you keep the clockspring from turning between removing & refitting the wheel ( a | + | Make sure you keep the clockspring from turning between removing & refitting the wheel ( a strip of tape may help with this if the wheel is going to be off for a while but normally you can just hold it while you put down the old wheel & pick up the new one. |
− | + | ||
− | strip of tape may help with this if the wheel is going to be off for a while but normally you | + | |
− | + | ||
− | can just hold it while you put down the old wheel & pick up the new one. | + | |
Line 181: | Line 133: | ||
Basically reverse the removal instructions to refit the steering wheel. | Basically reverse the removal instructions to refit the steering wheel. | ||
− | + | Only pointt worthy of a mention is to switch on the ignition after refitting everything from outside the vehicle just incase the airbag deploys ( once again unlikely but must be mentioned given the fact it can occasionally happen ) | |
− | + | ||
− | outside the vehicle just incase the airbag deploys ( once again unlikely but must be mentioned | + | |
− | + | ||
− | given the fact it can occasionally happen ) | + | |
[[Category:Mondeo_Mk3]] | [[Category:Mondeo_Mk3]] |
Latest revision as of 15:57, 28 February 2012
Now on its 4th incarnation, it remains a drivers favourite.
For more information, visit the Ford Mondeo
forum on TalkFord.com, the definitive resource site covering all
Fords from the present day to the 1970's.
Overview Guide | |
Ford Model: | Mondeo |
---|---|
Petrol/Diesel: | ???? |
Estimated Cost: | ???? |
Difficulty? | ???? |
How long does this take? | ???? |
Contents
Approx Fitting Time & 1st Things To Check For
15-20 mins + 15 mins airbag system drain time if required.
If the ignition has recently been switched on then you will have to wait 15 minutes minimum for the airbag system to fully discharge or disconnect the battery & wait again just to be 100% safe.
Parts Required
T30 torx bit screwdriver
Small flat screwdriver
24mm Socket ( deep socket if you have one )
Small extension bar ( if you dont have a deep socket )
T-bar for the socket.
Optional - Power Bar incase the t-bar aint shifting the bolt ( it can be tight if never undone since the car was made )
Piccies of the kit.
Instructions
Airbag Removal
Turn the ignition key just enough to unlock the steering lock ( but dont engage the ACC / I Position ( if you do engage said position then switch off the ignition & make sure to wait 15 mins before you progress further to allow the airbag system to drain - unless you have disconnected the battery of coarse )
Turn Steering wheel 90 Degree's from the striaght ahead position
Locate the screw hole that is now at the top of the steering wheel back & insert the torx screwdriver & undo the screw
Turn the steering wheel 1800 degree's in the opposite direction & undo the screw found at that side.
While making sure to support the airbag for falling, turn the steering wheel to the straight ahead position & remove the ignition key & enable the steering lock.
carefully pull the airbag forwards & suitably support it to allow you to work behind the airbag.
Now undo the 2 clips on the rear of the airbag itself ( just squeeze the little tabs at the side & pull normally, occasionally though your airbag may have actually been fitted correctly & the locking tabs applied so if the side tabs do not press, slide the yellow locking tab towards the rear of the plug ( where the cables are ) & then try the tabs again.
Now for the final connection holding the airbag inpace, the horn/cruise buttons connector.
Using a small flat screwdriver/bit push the locking tab down on the connector plug & pull the plug from the clockspring.
Now you can remove the airbag & store it safely ( badge side facing upwards just incase it goes off ( then you dont have to remember to watch for it coming down again when it scares the life out of you :} - never had this happen after many airbags have been removed but best to advise about it being possible.
Steering Wheel Removal
Undo the bolt in the middle of the steering wheel a few turns - & only a few turns mind, you dont want that bolt out fully just yet.
Now give the steering wheel a good tug & it should pop loose & stop when it hits the bolt once again ( best done this way than getting a face full of steering wheel if the bolt is fully removed with the wheel still stuck inplace - the wheel may not always be stuck but when it is its on well lol )
This piccy shows the spring mounted behind the wheel that helps you get a face full of wheel if you fully remove the bolt when the wheel is stuck inplace.
Make sure you keep the clockspring from turning between removing & refitting the wheel ( a strip of tape may help with this if the wheel is going to be off for a while but normally you can just hold it while you put down the old wheel & pick up the new one.
Refitting
Basically reverse the removal instructions to refit the steering wheel.
Only pointt worthy of a mention is to switch on the ignition after refitting everything from outside the vehicle just incase the airbag deploys ( once again unlikely but must be mentioned given the fact it can occasionally happen )