We now manually approve all new user accounts due to a large influx of spam bots. Accounts are normally approved within 48 hours.
If you need any help with using this Wiki, please ask here: TalkFord.com Wiki Submission Forum
Waterpump belt (TDDi) change
|How long does this take?||????|
TDDI Waterpump Belt Change
If your car has an engine cover, check the areas around the oil filler cap & dipstick aren’t full of grit (brush/hoover/wipe if they are), undo the oil filler cap & pull out the dipstick & whip the cover off. Refit the dipstick & oil filler cap, and remove the battery box cover to improve access – tie a big of rag or similar around the battery positive terminal to prevent a nasty short;
Unclip the hose that runs along the top/front of the head from the clips (4 of them) & tie it back (e.g. round the oil filler hole);
Undo the two hose clips (use a 6mm spanner) that hold the inlet manifold to metal pipe rubber elbow on, & remove the elbow. Mine was filthy with oil & soot on the inside, don't be shocked if yours is too;
There are two bolts (use a 10mm spanner) that hold the metal turbo pipe onto a bracket on the side of the engine, you'll need undo those to let you get the belt off;
On the top of the tensioner, you'll see a 1/4" square hole - use a socket ratchet to rotate the tensioner clockwise. If you haven't got a 1/4" ratchet, get one because it makes it very easy - you can't do it just by tugging on it;
With the tension off the belt, you can ping the belt off the cam pulley, then de-tension again to get the belt between the tensioner wheel & the inside of the metal turbo pipe bracket, then winkle the belt out between the outside of the bracket & the pipe (the 10mm bolts you removed earlier).
To fit the new belt (FINIS code 1120199), loosen the tensioner again, & _carefully_ move the belt through the gap, pass the other side through the turbo pipe/bracket gap, fit one end on the water pump pulley, then de-tension again to fit over the cam pulley;
Check the belt is aligned properly, then refit the 10mm bolts. This may be difficult – I found the metal pipe & bracket wouldn't line up without someone else leaning on the pipe, tighten as much as you can one handed on a regular spanner;
Refit the rubber inlet hose & tighten the hose clips - I just did them up as tight as I could with a 6mm socket on a 3/8ths extension bar, one-handed screwdriver style.
Untie the front coolant return hose & refit to the clips, check the front inlet manifold hose clip isn’t in a position where the coolant hose will rub on it.
Refit the battery cover Start the engine & check alignment again. Refit the engine cover, if you have one.
Final suggestion - keep a 6mm socket & bits handy for a few days in case I'm wrong about the torque on the hose clips. :)