We now manually approve all new user accounts due to a large influx of spam bots. Accounts are normally approved within 48 hours.
If you need any help with using this Wiki, please ask here: TalkFord.com Wiki Submission Forum
Throttle Position Sensor
A bad TPS can have many effects:
- Hesitation on acceleration
- Rough idle
- Rough running
Means of identifying a bad TPS
Fault Code Reader
Extract the fault codes using a FCR (fault code reader), like one of Ford's WDS apparatuses, or a similar device which is EEC compliant.
Check TPS connector for cleanliness
- Remove the connector from the TPS by pushing the securing spring, and then pulling the plug down.
- Check for any corrosion or deposits. They should be spot clean.
- Clean the connector using some contact spray, if need be.
- Reconnect the connector and lock the securing spring back into place.
GDS (Ghetto Diagnostic System)
It is a foolproof method. It requires only a metal pin, a multimeter with high imput impedance (any digital model will do) and some crocodile clamp leads.
- Connect the black (negative) lead to a CLEAN engine part (ground)
- Set the multimeter to the range that allows measurement of 0-15V (usually that will be 20V. Only DC will work.
- Use a set of pliers to force the pin THROUGH the middle lead.
- Connect the TPS to the connector
- Connect the red lead to the pin
- Switch on the ignition, but DO NOT START THE ENGINE.
- The multimeter should read at least 0.4V.
- Move the throttle SLOWLY through its entire range while watching the multimeter:
- When the trottle is full open, the meter should read 4.2V or more. (max 5V).
- Go through this process several times, as slowly as possible. You should see 0.01V steps.
The readout should, at all times, follow the linear motion of the throttle. If, the throttle is slowly opened, the readout should NEVER drop. If the throttle is slowly closed, the readout should NEVER rise. Not even for a short blip. If it falls to 0 at any given time, that is a 100% sure fire way to tell the TPS is gone.