Registrations

We now manually approve all new user accounts due to a large influx of spam bots. Accounts are normally approved within 48 hours.

If you need any help with using this Wiki, please ask here: TalkFord.com Wiki Submission Forum

How to remove a dash surround and cluster.

From www.FordWiki.co.uk
Revision as of 09:48, 27 August 2009 by Stevieb12345 (Talk | contribs)

Jump to: navigation, search

Removing a MK2 dash surround and cluster.

Things you need.

1. Phillips screwdriver.

2. Large flat butter knife. (Do not use a sharp knife!)

3. A old rag.


1. Pull the steering wheel as far down and out as possible. This gives you more room to work.

2. Wrap the rag around the end of the knife and slide it between the clock and dash surround. (see first picture.) Now carefully prize the clock out.

DSC00042 800x589.jpg

3. Undo the electrical connector on the back on the clock.

4. Now using the same knife and rag remove the heated window switch.

5. With the clock and heated window buttons out of the way,We now need to remove 5 screws! (See picture for the position of the screws) Remove the two screws in the clock area and then the screw where the heated window switch was. The next two screw are a little harder to get at and you might need a longer screwdriver. (See third picture for position and fourth picture on how to remove.)

DSC00043 800x600.jpg

DSC00044 800x598.jpg

DSC00045 800x581.jpg

6. With all the screws removed you can now remove the dash surround,It should just pull out. DSC00047 800x600.jpg


7. Now the the dash surround has been removed we can get to the cluster. There are 5 gold colour screw that now need removing. (See picture)

DSC00049 800x599.jpg

8. Once all five screws have been removed you can pull the cluster forward a little bit. This is to allow you space to get your hand in behind to undo two wiring connectors.

DSC00050 800x600.jpg

9. The cluster should now just lift out.

--Stevieb12345 13:27, 27 August 2009 (UTC) ‎