Registrations

We now manually approve all new user accounts due to a large influx of spam bots. Accounts are normally approved within 48 hours.

If you need any help with using this Wiki, please ask here: TalkFord.com Wiki Submission Forum

Handbrake Cable Rattle

From www.FordWiki.co.uk
Revision as of 15:51, 22 April 2011 by Bumdump1 (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search
The Ford Mondeo hit our roads in 1993, and has consistently been a sales success. Now on its 4th incarnation, it remains a drivers favourite.
For more information, visit the Ford Mondeo forum on TalkFord.com, the definitive resource site covering all Fords from the present day to the 1970's.

Fordwiki infobox.png
Overview Guide
Ford Model: Mondeo
Petrol/Diesel: ????
Estimated Cost: ????
Difficulty? ????
How long does this take? ????

The Mk3 Mondeo (hatchback and saloon - estate is different) is prone to a number of rattles from the rear suspension. These can be from worn subframe bushes, worn drop links, failed anti-roll bar bushes, broken springs and several other root causes.

One of the most common causes, however, is the handbrake cable being loose in its clip onto the rear suspension arm. This is easy to check and virtually free to fix, so ensure this is done on both sides before spending any money on other bits.

Hb-fix-1.jpg

This picture shows the location of the offending clip (circled in red). The cable should be absolutely rock solid in here: any slight movement can result in a disproportionate amount of noise in the cabin over low-speed bumps.

You do not need to remove the wheel or even raise the car, I've just done so for clarity. You could park the car on a kerb or suitable planks of wood, and work from underneath. If you do choose to jack the car up and remove the wheel, the usual warnings apply. If you don't know what you're doing, don't do it.

It's easiest to work with the handbrake released, as there's more slack in the cable. Only do this on level ground with the car in gear and securely chocked to prevent it moving.

If your cable is loose, remove the metal clip from the arm by pushing the tab at the bottom inwards, as this gives you more freedom to work. Build up the thickness of the cable at the appropriate point with a suitable tape - I used classic Duck Tape here - so that the cable is now tight in the plastic clip. Try to taper the thickness and wrap the tape such that the exposed edges face in the direction that you'll be pushing the cable back into the clip.

Refit the metal clip to the arm, locating it into the dip in the flange on the top of the arm, then pushing the bottom into the arm until it clicks. For a belt-and-braces approach, apply a cable tie to further reduce movement - put it underneath the ABS wiring as shown, being careful not to put any extra stress on that part. I've used a white cable tie as that's what I had. If you're pedantic about appearance, you may want to use a black one. You'll need to use a fairly long tie (~200mm) or daisy-chain two together. Cut the ends off when finished for neatness.

Close-up of the fixed area:

Hb-fix-2.jpg

badmonkey's fix, using black ties:

Badmonkey-hbc1.jpg

Badmonkey-hbc2.jpg