Difference between revisions of "Brake Pads - Changing Rear"

Revision as of 20:26, 7 March 2007

Changing Rear Pads on a Mk3 Mondeo

Caution - Before You Start

• Slacken all wheel nuts slightly before jacking car
• Remove the wheel
• Before working underneath the car, always support it firmly with axle stands!

Here We Go...

• Release handbrake cable from actuator on rear of caliper. The 'good book' says "push the lever forward" to allow nipple on cable end to be lifted from location. I defy anyone to 'push' it. It is attached to a very strong return spring. It must be levered forward, using a large screwdriver between the arm and the lower end of the caliper. Whilst this is done, cable nipple is lifted out, then lever is released. The end of the cable outer is held by either a spring clip or plastic grommett. Ours had a clip, which is pulled sideways from a groove in the cable outer, thus allowing the cable, which is now free, to be withdrawn clear of caliper. Lower guide pin bolt is now removed (1/2 inch AF) and inner caliper frame hinged upwards, leaving pads in position either side of disc.

• Next comes the 'interesting' bit! The piston will be fully extended, as in nornal calipers, and must be pushed back into housing. Unfortunately, because the self adjusting handbrake mechanism operates on a threaded piston located behind the front piston, which rotates as the handbrake is operated and thus takes up any wear, the front piston cannot be returned by normal means. It must be pushed back, whilst rotating it, to screw the threaded rear piston back into the housing. A 12mm hexagon socket is located in the centre of the piston, for this purpose and hence a 12mm Allen key is required! (Haynes, of course, just say use an Allen key). On right hand caliper, the piston must be pushed hard whilst rotating it clockwise. For the left hand caliper it must be rotated counterclockwise. (Estates, it says, are the opposite way round!) This task was not easy, and at first I thought the piston was not going to go in. You must persist and push very hard, whilst an assistant holds the caliper.

• With piston retracted, general clean up is done with brake cleaner fluid and copper grease applied to all pad contact points. The piston has a long and short cut-out, on opposite sides, and these must then be aligned with a raised casting pip on the outer rim of the piston housing. For reasons I cannot see, the long cut out must be aligned with the pip on the Right hand side wheel caliper and the short one on the Left hand side caliper. The 12mm Allen key is again used to rotate them into their correct positions. The new pads are then fitted, the caliper inner hinged down and secured with the screw, after applying Loctite threadlock.

• Reconnect handbrake cable, in a similar manner to when removed.

• Apply handbrake several times to take up slack. Fit wheel and job is done!

It's quite an involved affair the first time, but second wheel can be done in about 30mins!

Submitted by Kayball