Registrations

We now manually approve all new user accounts due to a large influx of spam bots. Accounts are normally approved within 48 hours.

If you need any help with using this Wiki, please ask here: TalkFord.com Wiki Submission Forum

Droplink Replacement - Rear

From www.FordWiki.co.uk
Revision as of 15:57, 22 April 2011 by Bumdump1 (Talk | contribs)

Jump to: navigation, search
The Ford Mondeo hit our roads in 1993, and has consistently been a sales success. Now on its 4th incarnation, it remains a drivers favourite.
For more information, visit the Ford Mondeo forum on TalkFord.com, the definitive resource site covering all Fords from the present day to the 1970's.

Fordwiki infobox.png
Overview Guide
Ford Model: Mondeo Mk3
Petrol/Diesel: ????
Estimated Cost: ?
Difficulty? ?????
How long does this take? ?????

UNDER CONSTRUCTION http://www.talkford.com/topic/138367-does-someone-want-to-make-this-a-wiki/


The tools/Equipment needed, WD40 A good sturdy jack with a SWL in excess of your car 2 solid jack stands with a SWL in excess of your car 2 wheel chocks ½ Drive ratchet with 19mm socket (Wheels) and 13mm socket for ARB Bracket 5mm Allen key 15mm spanner (Ratchet spanner would be ideal) ½ Drive torque wrench (for your wheels) Large flat ended screwdriver Your cars locking wheel nut (if applicable)

To start place the car on a flat surface and engage either 1st gear or reverse and chock both front wheels, loosen all the rear wheel bolts and then jack the car and place in the axle stands in accordance with your cars manual.

Resized to 59% (was 1023 x 682) - Click image to enlargePosted Image


Resized to 59% (was 1023 x 682) - Click image to enlargePosted Image


Next remove both rear wheels and store the so as not to damage them.

Resized to 59% (was 1023 x 682) - Click image to enlargePosted Image


Now with both the wheels out of the way you can see both of the offending articles on either side very easily. The drop link is Red and the ARB bush is Green. Give all the nuts a good soak in WD40 and then go and have a good cup of tea (or watch a bit of F1 in my case)

Resized to 59% (was 1023 x 682) - Click image to enlargePosted Image


Resized to 59% (was 1023 x 682) - Click image to enlargePosted Image


Now you can remove the nuts holding the Drop links on, you need a 15mm spanner (this is where I wished I bought a ratchet spanner set) and a 5mm Allen key to stop the ball the whole thing from spinning as you attempt to undo it, the bottom ones are a bit more fiddly due to the hub, calliper and handbrake cable being in the way but with a bit of fiddling you will get there

Resized to 59% (was 1023 x 682) - Click image to enlargePosted Image


Resized to 59% (was 1023 x 682) - Click image to enlargePosted Image


Once that is done you should just be able to pull them out and replace with a new shiny one!

Resized to 88% (was 682 x 1023) - Click image to enlargePosted Image


Then just pop the new one in and tighten up the nuts

Resized to 88% (was 682 x 1023) - Click image to enlargePosted Image