Registrations
We now manually approve all new user accounts due to a large influx of spam bots. Accounts are normally approved within 48 hours.
If you need any help with using this Wiki, please ask here: TalkFord.com Wiki Submission Forum
Difference between revisions of "Engine Removal (V6 Mondeo Mk2)"
| Line 17: | Line 17: | ||
|header2 = | |header2 = | ||
|label2 = Petrol/Diesel: | |label2 = Petrol/Diesel: | ||
| − | |data2 = ''' | + | |data2 = '''Petrol''' |
|header3 = | |header3 = | ||
|label3 = Estimated Cost: | |label3 = Estimated Cost: | ||
Latest revision as of 06:37, 17 June 2011
For more information, visit the Ford Mondeo forum on TalkFord.com, the definitive resource site covering all Fords from the present day to the 1970's.
 Overview Guide | |
| Ford Model: | Mondeo Mk2 |
|---|---|
| Petrol/Diesel: | Petrol |
| Estimated Cost: | ? |
| Difficulty? | ????? |
| Source | TalkFord.com |
V6 engine removal how-to
1. take battery off and battery tray (mark every nut,bolt and wiring with tape or plastic bag)
2. jack car up and take off exhaust, (the y pipe )
3. remove the front/rear manifold off from the engine, drain the oils trans/engine/ remove filter
4. undo the front and rear roll resistors, undo the water screw on radiator and drain
5.remove the alternator belt
6. remove the three bolts and take off the aircon pump and tie it down to the car away from engine
6a remove driveshafts from hub and take off black driveshaft mount from engine block
6b remove alternator wiring loom and remove alternator bracket from engine w alternator, again don’t need to take off alternator but gives more room,
7. remove air filter and all hoses,
8. remove the clutch hydraulic lines and all the shift cables completely
9a. depressurize the fuel lines by pulling fuse 14 fuel pump fuse
9.b remove fuel lines with homemade plastic tool
10.disconect all the wires from the transmision multi plugs, earths etc
11. disconect the 2 O2 sensors from the front and rear wiring loom
11. remove the coolant hoses all of them from the radiator
12. remove the coil pack and disconnect leads and earth, again not need to remove but it helps with space
13. remove the upper and lower inlet manifold from engine
14. undo the powersteering pipes union and tie it back
15 undo the 2 nuts holding the wiring loom to the rear of the cylinder head 8mm iirc
16 undo the 2 nuts holding the front radiator pipe from the engine block
17 tie straps to the top of the engine towing eyes
18 undo the two top mounts from the engine bay
19 slowly lift the engine and gearbox out of the top of the car with a friend to guide u with an engine crane.
Your Privacy Choices