Search results

Create the page "Idle" on this wiki! See also the search results found.

• Ford Diagnostic Codes List
  ...on range selector in gear (DRIVE or REVERSE) or when closing the throttle (idle) after opening it (in PARK or NEUTRAL) the TP closed throttle position is n ...stop, turn key OFF. Start vehicle, run key ON engine running self-test at idle. Access KOER diagnostic trouble codes on scan tool.
  103 KB (16,794 words) - 05:13, 3 March 2011
• OBD-II - Fault Codes
  * P1505 Idle Air Control System at Adaptive Clip * P1506 Idle Air Control Over Speed Error
  52 KB (7,232 words) - 16:54, 22 April 2011
• Engines - Diesel Models
  ''Idle speed:'' 900 rpm ''Idle speed:'' 900 rpm
  8 KB (1,138 words) - 20:08, 20 February 2011
• Engines - Petrol Models - 2007 onwards
  ''Idle speed:'' 780 rpm ''Idle speed:'' 780 rpm
  6 KB (762 words) - 23:47, 20 February 2011
• ECU Basics
  ...e position is used to control the open/closed loop transition and also the idle/part throttle transition. It can be logged in volts, counts, and counts rel ...nce between the manifold and the fuel rail. If your manifold is at 20inHg (idle), you only need 30psi of rail pressure, but if you are only at 5inHg (typic
  12 KB (2,153 words) - 16:23, 27 November 2011
• Injector Leak-Off Test
  The test that I used starts with 2 minutes running at idle followed by: 30 seconds at idle followed by:
  5 KB (813 words) - 10:07, 24 February 2016
• Air Conditioning - An Idiot's Guide (Overview)
  ...is requested, the idle speed is normally increased slightly. If a minimum idle speed is not reached, the AC will be deactivated '''A''' Engine idle speed might be too low or the fan may not be working – see above
  6 KB (992 words) - 16:41, 20 July 2017
• Throttle Hang Fix
  ...C cables. This plug has a hole drilled in it to provide sufficient air for idle RPM control but insufficient to maintain a RPM of in excess of 3K. The thro ...first time I started it, the engine "hunted" before stabilizing at 750RPM idle. Did this for when the lights were on and the AC. The ECU is learning the n
  5 KB (754 words) - 23:41, 20 February 2011
• EGR Valves - Explanation
  ...zero load) because it would cause unstable combustion, resulting in rough idle. ...ys operate with excess air, they benefit from EGR rates as high as 50% (at idle, where there is otherwise a very large amount of excess air) in controlling
  8 KB (1,304 words) - 10:02, 10 June 2009
• V6 - IACV - location - moosing
  == IACV(Idle Air Control Valve) location ==
  1 KB (218 words) - 20:49, 20 February 2011
• V6 Head Gasket Replacement
  ...tle cable mounting bracket ( 3 screws I think ) , remove the plug from the idle control valve, disconnect the hoses from the EGR and undo the 2 bolts , dis Remove the AUX belt and the AUX Tensioner and the idle pulley.
  16 KB (2,885 words) - 21:28, 23 April 2011
• CD4E Oil change (Mondeo Mk1/2/3)
  ...PARK position, fully set the parking brake and leave the engine running at idle. * 8. Start the engine and let it idle. If you have not yet applied the park break, then do so. Pull the brake ped
  8 KB (1,283 words) - 20:04, 20 February 2011
• Auxiliary belt tensioner replacement
  ...causing a tinny rattle to the engine, particularly at, or slightly above, idle. It also causes superfluous vibration of the belt, which must accelerate we ...y with the bonnet open, the engine cover removed and the engine running at idle. The aux belt is on the left hand side as you stand at the front of the car
  7 KB (1,121 words) - 21:25, 23 April 2011
• Acronyms and Abbreviations
  IACV: Idle Air Control Valve ICV: Idle Control Valve
  11 KB (1,611 words) - 01:26, 14 December 2010
• Finis
  * Idle Speed Control Valve for V6: 4429072
  9 KB (1,114 words) - 05:43, 25 September 2007
• Alternator Replacement V6 Duratec
  ...by having to disconnect the battery?)and as a bonus the squeaking noise at idle has disappeared.
  4 KB (634 words) - 23:03, 20 February 2011
• ECU Reset
  To allow the PCM to relearn, start the engine and run it as close to idle speed as possible until it reaches its normal operating temperature
  3 KB (486 words) - 21:25, 23 April 2011
• Throttle Position Sensor
  *Rough idle
  3 KB (512 words) - 20:45, 20 February 2011
• V6 Moosing Noise
  For the ST220 3.0 V6 this moosing noise can be caused by a faulty idle air control valve. For an 03 pre face lift ST220 the part numbers required
  2 KB (224 words) - 20:51, 20 February 2011
• Oil - All You Ever Wanted To Know
  ...helf, the same thing is going to happen inside your engine when it is left idle for any period of time.
  82 KB (13,424 words) - 20:29, 20 February 2011
• Finis Codes
  Idle Speed Control Valve for V6: 4429072
  9 KB (1,213 words) - 16:22, 27 April 2009
• Intake Manifold Removal
  10. Disconnect the throttle position (TP) sensor and the idle air control (IAC) valve electrical connectors.
  5 KB (726 words) - 18:26, 22 April 2011
• Power Steering Fluid Change
  10. Start the engine up, let it idle for a bit and make sure your pipe isn't leaking on the cooler. If the reser
  4 KB (609 words) - 00:26, 16 January 2011
• Lambda Sensor Operating Voltage
  ...asurements to be taken after a few blips of the throttle & left to drop to idle.
  1 KB (136 words) - 10:39, 20 September 2011
• Engine over revving
  ...l when I braked and the car came to a stop. I initially thought it was the idle control valve and replaced it with no effect. I'm lucky I have Tremona gara
  754 B (138 words) - 15:54, 27 November 2011
• Common Rail Injector Types
  ! scope="col" | Idle
  4 KB (672 words) - 14:04, 1 May 2015